• Monitor yields, loads, waste and compliance
  • Document truck weights and eliminate overload fines.
  • Determine and maximise your load and axle weights before you go over a weighbridge.
  • Relocatable design for rented or variable work sites

Drive over the scale at a constant ~3MPH (~5km/h). The scale will automatically weigh each axle and print a receipt with individual axle weights and the total. If you store the truck’s ID and tare weight, or use 2-pass weighing, the controller will calculate the Gross, Tare and Net values.

Easy

Just install, turn on power, zero the scale and start weighing. The Weigh-In-Motion Axle Scale is preconfigured for easy installation. The load cells are factory calibrated and the indicator is pre‑programmed. All wiring is DIY terminating with screw on watertight M12 connectors.

Accurate

On average, better than ± 0.5% repeatability can be expected. Company testing as well as numerous field installs have shown that better accuracy can be achieved with extended flat and level concrete approaches. Individual results may vary. Well-maintained vehicles weigh the best. Never worry about being overloaded again.

Economical

About ⅓ of the cost of a full-length truck scale. With the Weigh-In-Motion Axle Scale, you will always know the total vehicle weight and the individual axle weights. Installation generally takes half a day and no costly foundation work. No limit on the number of axles, allows for any truck configuration or length. Can even be installed in a gravel driveway removing the need for costly approaches and exits.

Innovative & Trusted

This patented design produces fast and accurate weights without stopping on the scale or interrupting the flow of traffic. Farm and jobsite management software creates a CSV file for every transaction with “farm and field” or “material and Job #”. The axleWEIGHr in-motion axle scale patent is approved as US Patent 9470574.

Single Pass Weighing With Known Tare Weight

  • Configure the truck’s empty weight
  • ID the truck and proceed across the scale

Two Pass Weighing – Weigh In and Weigh Out

INBOUND

  • ID the Truck and then drive across the scale

OUTBOUND

  • ID the Truck again and drive across the scale

Downloads

Operator Manual ( R400-665-300)

Operator Sheets  ( R400-664-131 )

AxleWEIGHr Test & Calibration Calculator  (AXLE-804-301)

In-Motion Vehicle Scale Brochure (AXLE-708-250)

Whitepaper on axleWEIGHr Scale Use ( AXLE-711-100 )